If you are in a hot environment for hours, this is a great solution to make you more comfortable! The system is very efficient and effective because it is focused on just cooling YOU down, and not the entire vehicle.
Each package includes:
1 – beaded seat cover with tubing passing throughout the beads – You choose which side of the seat cover you would like the tubing connectors. (This will depend on where you would like to put your cooler.) These seat covers are handmade in Thailand!
1 – 17-quart cooler for ice and water (Cooler color may vary)
1 – DC Power plug with a cord-length that you select **PLEASE SEE NOTE BELOW**
1 – length of insulated tubing to go from the cooler to the seat cover (optional lengths)
1 – 20-foot roll of loop strapping to attach the seat cover to almost any type of seat*
The units are powered by plugging into your vehicle’s DC power port, but you may also choose to add the 12V rechargeable battery pack to power the system.
-FREE STANDARD SHIPPING TO THE LOWER 48 U.S. STATES, BUT WE HIGHLY RECOMMEND UPGRADING TO PRIORITY SHIPPING!
Please note: These seat covers are intended to cool the user down to a comfortable level. It is not, however, recommended that the user expose bare skin to the tubing for more than a few minutes at a time as skin / tissue damage may occur. Please consult a physician if you have any health conditions that may be adversely affected from being exposed to cold temperatures. Please stop using the device if numbness occurs in any areas that are in contact with the device.
These beaded seat covers may not be a good idea for a person that does not wear a seat belt! The beads are comfortable to sit on, but they can also be slightly on the slippery side due to the rolling nature of the beads. This may cause a user to slide around slightly on the seat, therefore we highly recommend wearing your seatbelt!
* – These covers come with Velcro-style straps attached to the seat covers that will easily attach to a seat with wool-type backing. To attach to a seat that does not have a wool-type backing, the included loop strapping will need to be cut and used to attach from seat cover strap to seat cover strap, under and / or around the seat. If there is not access under and behind the seat and the seat does not have the wool-type backing, the seat cover may not be able to be attached to the seat. If a strap can go under the seat (both side-to-side and front-to-back) and behind the seat, then it will most likely be able to be attached to the seat with the included strapping, assuming the seat is the correct size. Unfortunately, these seat covers will not work on seats where the seatbelt is built into the seat.
Measurements of the seat cover are approximately 46″ L x 18″ W x 1/2″ T
** – Unless you opt to use a battery pack, power needs to get from the vehicle’s DC power plug outlet to the cooler. Please make sure that you select a power cord long enough to route the wire from your vehicle’s power outlet to the cooler in a safe and out-of-the-way area.